products
contact us
- address：suite 807, tianan hi-tech development plzaza. no.555 north panyu road, panyu districtguangzhou, china.
- tel：020-39211238
- fax：020-39211286
durakote pmc-600
brands：durakote
types：
field of application：
introduction：durakote pmc-600 is blend of organic solvents designed to remove dirt, grease and contaminants form a mould surface. duraktoe pmc-600 is particularly efficient at removing silicone, wax or other types of build-up on the mould. durakote pmc-600 is designed not to soften or dull mould materials (such as grp). consequently, durakote pmc-600 can be used on any metallic or thermoset moulds. durakote pmc-600 should be used immediately prior to the application of durakote sealer or release agents.
|
product benefits |
physical properties |
|
l efficient cleaner l medium dry time l non-chlorinated solvents l versatile, can be used on all mould surfaces
|
appearance - clear, colourless liquid odour - ketone/hydrocarbon specific gravity - 0.848 g/cc flash point -<10℃ shelf life - three years storage - flammable store(see msds) |
note：
mould cleaning must be performed in a well-ventilated area. solvent resistant gloves and eye protection must be worn during this process.
application：
please read safety data sheet before use.
heavy build-up and resin deposits may be removed by an abrasive medium. e.g. polishing compound or even shot blasting, prior to using the durakote pmc-600. if necessary, polish mould to desired level of gloss prior to using the durakote pmc-600.
1.generously apply the durakote pmc-600 to clean, dry cotton cloth.
2.wipe over mould surface covering an area of approximately 0.5 m2。
3.with a second dry cloth, wipe off the wet film. do not allow the wet film to dry before wiping off as this will simply re-deposit contaminants picked -up by the solvent. continue wiping until the mould surface is dry.
4.repeat steps 1-3 on the adjacent area. ensure a good overlap with the previous area to ensure the entire mould surface is
cleaned.
5.if either cloth becomes dirty, or if the second cloth becomes wet, replace with a fresh clean cloth and repeat step 1-4.
6.frequently re-apply durakote pmc-600 to the wet cloth.
7.repeat until mould is completely cleaned.
test for cleanliness:
visually inspect the mould for signs of dirt or streaks. if necessary, repeat cleaning procedure in that area. to test the
cleanliness of the surface , apply a standard pressure sensitive tape(e.g. masking tape) to the mould surface. when the tape
is removed from the surface ,stiff resistance should be observed. if the t ape fails to stick firmly, repeat cleaning procedure.
note:
if polishing a grp mould, it is recommended that a non-wax containing polishing be used. if a polish containing a wax is used,
the wax produces an artificial gloss that will be removed by the durakote pmc-600 hence dulling the finish.
please contact us for further product and application information.
hotline：